V1.0.5 Not slewing CEM60

[nxda]

Since installing V1.0.5 I have lost the ability to slew my iOptron CEM60 from within the app. Anyone else?

 

The odd thing is I reinstalled V1.0.4 and I still can't slew the mount. I cannot think of anything that has changed.

 

Will 

[admin]

This is ASCOM related.  I think you might have changed something in ASCOM.

 

Oh, make sure your scope is not parked

[s3igell]

You have the Premium version of BYN??  One would assume so from "used to work".  Please make sure that you activated your v1.0.5 Install with your Premium key...

 

Beyond that, all that BYN provides is a Generic ASCOM Interface.  Everything else comes from your setup of ASCOM Drivers and Apps, and Cabling and Mount...

[astroman133]

If you Choose the ASCOM Telescope Simulator for .NET instead of your telescope, do BYE's scope control buttons change the RA and DEC of the scope?  If so, then you have ruled out BYN as the cause of your issue.

[nxda]

More info... So I was on V1.0.2 not V1.0.4 and slew control was fine... a little slow, but fine. I updated to V1.0.5 and although BYN said I was connected... the mount would not move. With the roll back to V1.0.4 the issue remains. The only thing that changed on my dedicated astro laptop was this update. 

 

Is it reasonable to assume that if there was an ASCOM issue BYN wouldn't show it as being connected?

 

Again, any help here is appreciated.

 

Will

[astroman133]

Did you try the ASCOM Telescope Simulator? What did you see?

 

I don't have BYN, but the BYE 3.1.6 scope control works just find to slew the Simulator.

[admin]

Send me the log file at support@otelescope.com.