Be as specific as possible when reporting issues and *ALWAYS* include the full version number of the application you are using and your exact *CAMERA MODEL*
NEVER POST YOUR KEY IN ANY PUBLIC FORUM, INCLUDING THE O'TELESCOPE SUPPORT FORUM ::: IF YOU DO YOUR KEY WILL BE DEACTIVATED WITHOUT NOTICE!
- 0
Question
primeclash
This evening I connected my D610. Then I started BYN. I edited the image plan to take 48 Bias frames and Saved. I clicked Start and BYN dutifully captured 48 Bias frames (saving to PC, incidentally).
I edited the imaging parameters to capture 24 DARK frames, 300 seconds each and Saved that Plan. However, when the plan executes, only a single exposure is captured.
I restarted my laptop and loaded the plan again. Still BYN will only capture a single exposure before 'finishing'. I can only capture one frame at a time.
I have noticed this behavior before and I'm relegated to attending my imaging session to press the button.
What might I be doing wrong here?
Regards,
Louis Marchesi
Link to comment
Share on other sites
8 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.