Frame and Focus defaults

[RadOD]

D750 on BYN 2.0.1 on a Dell XPS15 with Win10

 

Every time BYN starts, Frame and focus defaults to the highest ISO (Hi-2.0) and a seemingly random shutter speed.  

 

  -Is there any way to choose a defult?

 

If I choose BULB, if I don't click duration just the right way right it becomes unselectable and I need reselect BULB again.  Also, as soon as I take a snap image, duration blinks off and I need to choose BULB over again before I can change the duration.

 

  -Any fix for this?  This adds a lot of time to focusing.

 

[admin]

It's not random.  It defaults to settings that are known to produce high sensitivity live view frames images.

 

If you don't want this go to Settings -> and uncheck "Maximum Sensitivity".

[RadOD]

I disabled max sensitivity but I still have problems:

 

Here's what I'm doing:

 

1. Start BYN
2. Connect to D750
3. Click Frame and Focus
4. Set Shutter to Bulb, 5, 12800, 0
5. Snap Image.  I get the image ok but duration is now blank, shutter changes to 1
6. Snap Image (not changing anythting).  Works but 1s exposure.
7. Again set to Bulb, 5, 12800, 0
8. Again, Snap Image.  Works, but now it has changed itself to Bulb, blank!, 12800, 0
9. Now if I snap an image I get "Busy 1" and a spinning circle in the top right.  I have to turn off camera and reconnect to do anything else.

 

This adds a lot of time to focusing.

 

I can upload screenshots if desired.

[admin]

Is your camera dial set to bulb?

 

Do you have mirror lock enabled?  This needs to be off.

 

If you try Time Value instead of bulb what do you get?

 

Regards,

[RadOD]

I was not on bulb!  I thought that might fix it but no luck - same behavior when camera is on bulb, M, and manual focus.  Can't even choose a bulb value without first choosing a time then going back to bulb.

 

Mirror lock is off.  (Doubt its important but I do use mirror lock sometimes - it works if I connect both the standard USB and DSUSB at the same time.  USB only right now though.)

 

Using time rather than bulb works normally.

[admin]

The fact that timed value works and not bulb is weird.

 

What version if BYN are you using?

[admin]

The fact that timed value works and not bulb is weird.

 

What version if BYN are you using?

 

 I see from your initial post you are using the latest 2.0.1.  This is good.

 

Which drivers are you using in BYN when connecting your camera?  Nikon or Nikon2015?

 

Regards,

[RadOD]

Nikon2015

[admin]

Try Nikon.  It may make a difference.