Search the Community
Showing results for tags 'LiveView Pause'.
Found 1 result
While performing some Planetary Imaging of Jupiter earlier this week, I had occasion to start using the new "True" LiveView Pause in both Frame&Focus and Planetary. I run with "Max Sensitivity" - for the obvious reasons. But, while working with Jupiter, it is Bright Enough that I need only 1/40sec at 400ISO. So, I set both Frame&Focus and Planetary Exposure Plans to that setting. Then, I found that whenever I used Pause (to save on LiveView Sensor Heating - it was 45*F Ambient instead of the 0*F that some of you are fighting), when I "Un-Paused" the Exposure Plan would immediately return to 2sec at 6400ISO (Max Sensitivity for my 60D). After about the 3rd round of resetting both the Exposure and ISO, this became OLD. I can understand asserting Max Sensitivity settings when one changes Mode into either of these LiveView modes (or at least when switching into Frame&Focus), but this Pause behavior is essentially becoming a "Pause Penalty" for anyone who is concerned to use this Pause Feature in order to reduce LiveView-generated Thermal Noise... Can this be fixed ?? Or is there an unobvious reason this Action must be ??