Jump to content

Canada's top-tier Telescopes & Accessories

Astrodon


2 products

  1. From $547.00 USD
    specialorder
    Scheduled Delivery

    Astrodon: Simplify Your Imaging!
    Astrodon LRGB Gen2 E-Series Tru-Balance Filters were designed for cameras containing the full-frame KAF8300, KAF3200, KAF6303, KAF16200, KAF16803 sensors, as well as most Sony and back-thinned sensors.

    Astrodon LRGB Gen2 E-Series Tru-Balance filters have revolutionized CCD imaging. Their popularity is due to their ease-of-use, high optical throughput and great resulting colors for galaxies, star clusters and nebulae.

    E-Series filters are designed to approximately equalize the flux of red-sensitive full-frame (formerly Kodak E-Series) CCD detectors, including compensation for the solar photon flux. This means that your RGB color combine weights will be approximately 1:1:1 within perhaps 10% for equal length exposures.  This can never be perfect, but it does allow you to take one exposure time for all of your RGB data and therefore, only just one corresponding dark exposure time.  Again, this saves you precious imaging time and thus, simplifies your imaging.

    The E-Series filters were designed for cameras containing the full-frame KAF8300, KAF3200, KAF6303, KAF16803 sensors. They are also a good choice for the latest Sony and back-thinned sensor.  The E-Series red filter is a deep red filter about 60 nm wide, which excludes much of the light pollution from high pressure sodium street lamps. Other filter suppliers try to “force fit” their orange filter (designed for the interline KAI11000, KAI2000 sensors) for use with these full-frame sensors. Their orange filter (see below)  is about twice as wide spectrally as our deep red filter.  As a result, their orange filter tends to “wash out” HII regions in galaxies and detail in nebula. Their blue and green color weights are no longer balanced and as a result, the OIII color in planetary nebula is skewed strongly toward blue, rather than the correct teal color. These are the reasons why Astrodon designed E- and I-Series filters for these different classes of cameras for optimum results.

    SPECIFICATIONS
    Set includes Luminance (NIR/UV-blocked colorless), Red, Green and Blue filters
    1.25″ mounted, 31, 36, 49.7 mm dia, 49.7 mm square (36 mm filters will not exceed 36.1 mm dia.)
     3 +/-0.025 mm single 1/4-wave fused silica substrate before coating
    30 arcsec parallelism
     ~1:1:1 color combine weights for G2V white-point for Full-Frame (E) detectors
    Best choice for back-thinned and Sony detectors
    Equal RGB exposures and one dark time
    Better color separation (see spectra)
    Better color rendition for galaxies based upon color theory
    Significant reflection and star halo reduction
    Enhanced contrast for HII regions in galaxies due to narrower red (not orange) filter
    Spectral “gap” between green and red filters to minimize effect of light pollution, especially from high pressure sodium street lamps (see spectra)
    Highest efficiency blue filter with less UV
    Correct “teal” OIII color for planetary nebula (OIII signal >97% in blue and green)
    Parfocal with Astrodon‘s high-performance narrowband, Clear and Near-IR Luminance filters
    Ultra-hard and durable sputtered coatings coated to the edge of each filter
    Proudly made in the U.S.A.
    Notice that Astrodon filters are coated to the edge. Other filters leave an uncoated “rim” (see below)  near the edge that must be blocked by a mask or the design of the filter wheel.  Our approach minimizes stray light from polluting your image.

  2. From $547.00 USD
    specialorder
    Scheduled Delivery

    Astrodon:

    Simplify Your Imaging!
    Astrodon LRGB Gen2 I-Series Tru-Balance Filters were designed for cameras containing the Interline KAI11002, KAI16000, sensors.

    Astrodon LRGB Gen2 I-Series Tru-Balance Filters
    Astrodon LRGB Gen2 I-Series Tru-Balance Filters are designed to approximately equalize the flux of  Interline CCD detectors (formerly Kodak), including compensation for the solar photon flux.  The I-Series filters compensate for the lower red response of these Interline detectors affecting the design of the Green and Red filters.  The Luminance and Blue filters are the same as those in our E-Series.  This means that your RGB color combine weights will be approximately 1:1:1 within perhaps 10% for equal length exposures.  This can never be perfect, but it does allow you to take one exposure time for all of your RGB data and therefore, only just one corresponding dark exposure time.  Again, this saves you precious imaging time and thus, simplifies your imaging.

    Set includes Luminance (NIR/UV-blocked colorless), Red, Green and Blue filters
    1.25″ mounted, 31, 49.7 mm dia.
     3 +/-0.025 mm single 1/4 wave fused silica substrate before coating
    30 arcsec parallelism
     ~1:1:1 color combine weights for G2V white-point for Kodak Interline detectors
    Equal RGB exposures and one dark time
    Better color separation (see spectra)
    Better color rendition for galaxies based upon color theory
    Significant reflection and star halo reduction
    Spectral “gap” between green and red filters to reduce the effects of light pollution
    Highest efficiency blue filter with less UV
    Correct “teal” OIII color for planetary nebula (OIII signal >97% in blue and green)
    Parfocal with Astrodon‘s high-performance narrowband and near-IR Luminance filters
    Ultra-hard and durable sputtered coatings coated to the edge of each filter
    Proudly made in the U.S.A.

×
×
  • Create New...

Important Information

This site uses cookies to offer your a better browsing experience. You can adjust your cookie settings. By closing this banner, scrolling this page, clicking a link or continuing to browse otherwise, you agree to the use of cookies, our Privacy Policy, and our Terms of Use