Help! Parameter is not Valid!

[gilbertgrape87]

I'm getting an error as soon as I try to use the camera. It connects OK, but as soon as I try to take an image during imaging, or enter planetary or F&F modes, it locks up on me. I have used this camera many times successfully with BYE before, last time used was on 1/9/2019. Any help would be appreciated, thanks!

Camera: Canon T6s

OS: Windows 10 x64 build 17134

BYE Version: 3.1.16 Premium

logfile-[20190120-21h44m22s997]-[6664]-2019-01-20.txt

[admin]

Looks like you may have turned off live view in the camera and it is not delivering a live view image.

Do you get a live view image on the camera LCD screen?

[astroman133]

Are you imaging with an autofocus lens or a telescope. Could it be that the camera is set to autofocus but the lens can't find focus at night?

It is most likely that or some other camera setting that you changes since you last used the camera.

[gilbertgrape87]

I am imaging with a telescope.

The first post asked whether or not live view was working on the camera screen, so I went and checked...

....no it's not. I've tried factory reset on the camera and ensuring live view is enabled. While the log I posted occurred when I tried live fire, the same goes when I take a picture from the imaging screen. I disconnected the camera from the computer and tried to snap a picture locally.... It freezes.

So....it would appear that my camera is broken... Which is weird because I just used it last week and it's been sitting on the scope the entire time.

Thanks to those that responded!