Jump to content

Canada's top-tier Telescopes & Accessories
Be as specific as possible when reporting issues and *ALWAYS* include the full version number of the application you are using and your exact *CAMERA MODEL*
NEVER POST YOUR KEY IN ANY PUBLIC FORUM, INCLUDING THE O'TELESCOPE SUPPORT FORUM ::: IF YOU DO YOUR KEY WILL BE DEACTIVATED WITHOUT NOTICE!
  • 0

Aperture Setting Lost in Frame & Focus


calaban

Question

Hi

Running BYE 3.1.11 (reinstalled in a different folder), take a few images, focus and adjust setup in Frame & Focus and after a short while and after switching back to Frame and Focus, I lose the Aperture notification.

Change Shutter to Bulb and Aperture reappears but no Duration. Back to set shutter speed (Manual) and Aperture there until I change Shutter speed and Aperture lost again.

See two attached images.

Camera EOS 1DX. ITX Computer. Noting of interest in the BYE Logs. Have  TemperHUM version : [TEMPer1F_H1V1.4F]

Thanks, appreciate the support,  Richard

 

Snap105.jpg

Snap108.jpg

Link to comment
Share on other sites

  • Answers 4
  • Created
  • Last Reply

4 answers to this question

Recommended Posts

Richard,

This issue has been discussed in a couple of other threads. I believe that it is a bug that was caused by other changes to BYE that were released in 3.1.10 and 3.1.11. To fix you could either temporarily go back to 3.1.9 or download the latest release candidate of 3.1.12. I would install the release candidate into a separate folder.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.


×
×
  • Create New...

Important Information

This site uses cookies to offer your a better browsing experience. You can adjust your cookie settings. By closing this banner, scrolling this page, clicking a link or continuing to browse otherwise, you agree to the use of cookies, our Privacy Policy, and our Terms of Use