Jump to content

Canada's top-tier Telescopes & Accessories
Be as specific as possible when reporting issues and *ALWAYS* include the full version number of the application you are using and your exact *CAMERA MODEL*
NEVER POST YOUR KEY IN ANY PUBLIC FORUM, INCLUDING THE O'TELESCOPE SUPPORT FORUM ::: IF YOU DO YOUR KEY WILL BE DEACTIVATED WITHOUT NOTICE!
  • 0

A new Polar alignment technique using BYEOS


STEVE333

Question

Below is a link to a YouTube video showing how to do precise polar alignment using BYEOS.  The technique is easy, and, I hope it helps you as much as it has helped me.

 

https://www.youtube.com/watch?v=mZWEtAV1zCw

 

I have always achieved misalignment errors of less than 1 arc min with this technique with only one iteration.

 

Happy aligning!

 

Steve

Link to comment
Share on other sites

  • Answers 33
  • Created
  • Last Reply

Recommended Posts

Hello Steve

 

  I had some time and clear skies last night.  I used your method for quick alignment and had the results described in your posts.

 

  I can't comment on how close the alignment was because visiting with neighbors and set-up goof-ups took up a lot of time.  I didn't get to spend too much time imaging to see how the PHD2 numbers were over a long time.  I did take a 7 minute guided exposure of M45 that came out good.

 

  I did have better numbers in in PHD 2 over last time I set up using your system.  Dec was below .5 arc seconds most of the time and total was below 2 arc seconds most of the time.  I will continue to use it and have a final evaluation at a later date.  I have several scenarios to try first.

 

Ron

Link to comment
Share on other sites

Hi Ron -

 

Just a short clarification on your comment

 

 The atmospheric modeling seemingly has to have a specific camera orientation to be effective.  Something I dont understand but accept.

 

The atmospheric modeling will work for any imaging camera orientation, so, you can orient your imaging camera any way you wish.  The atmospheric correction is only applied to the mount's Alt and not the camera's orientation.

 

Hope this makes sense.

 

Steve

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.


×
×
  • Create New...

Important Information

This site uses cookies to offer your a better browsing experience. You can adjust your cookie settings. By closing this banner, scrolling this page, clicking a link or continuing to browse otherwise, you agree to the use of cookies, our Privacy Policy, and our Terms of Use