Jump to content

Canada's top-tier Telescopes & Accessories
Be as specific as possible when reporting issues and *ALWAYS* include the full version number of the application you are using and your exact *CAMERA MODEL*
NEVER POST YOUR KEY IN ANY PUBLIC FORUM, INCLUDING THE O'TELESCOPE SUPPORT FORUM ::: IF YOU DO YOUR KEY WILL BE DEACTIVATED WITHOUT NOTICE!
  • 0

ASCOM Device Management Suggestion


astroman133

Question

The current behavior (BYE 3.1.7) is to make the Focuser the active device when switching between camera modes (F&F, Imaging, Planetary, Drift Align). I would like to see that behavior changed so that

1) the telescope is the default device rather than the focuser, and

2) that the active device does not change when the camera mode changes.  What I mean by that is that whatever the active device if I change BYE's camera mode from Frame & Focus to Imaging that same device is still active.

 

One user actually thought that their telescope was disconnected because they switched from F&F to Imaging and the active device was switched to the focuser!

Link to comment
Share on other sites

  • Answers 2
  • Created
  • Last Reply

2 answers to this question

Recommended Posts

Archived

This topic is now archived and is closed to further replies.


×
×
  • Create New...

Important Information

This site uses cookies to offer your a better browsing experience. You can adjust your cookie settings. By closing this banner, scrolling this page, clicking a link or continuing to browse otherwise, you agree to the use of cookies, our Privacy Policy, and our Terms of Use